{"product_id":"detektor-plynu-safe-808com-oxid-uhelnaty","title":"Detector SAFE 808COM carbon monoxide","description":"This product is a smart detector with voice warning designed to indicate the release of carbon monoxide and all commonly found explosive gases in households (natural gas, methane, propane, butane) and in living spaces without significant danger.\u003cbr\/\u003e\u003cbr\/\u003eThe device is ideally suited for gas detection from all domestic gas appliances, gas boilers and indicates the leakage of flammable gas used for heating, cooking or heating.\u003cbr\/\u003e\u003cbr\/\u003eThe SAFE 808COM is equipped with two independent sensors that do not require additional calibrations or a TEST button to start a function that allows the device to verify the serviceability of the internal circuits using an automatic efficiency monitoring system.\u003cbr\/\u003e\u003cbr\/\u003eThe device stands out for its measurement stability, high sensitivity, long service life and compact dimensions.\u003cbr\/\u003e\u003cbr\/\u003eThe device is controlled by a microprocessor and signals the leakage of CO and gas both optically and acoustically via an 85 dB buzzer.\u003cbr\/\u003e\u003cbr\/\u003eIf the detector detects a danger, the device will start an acoustic buzzer signal accompanied by flashing of the red \"ALARM\" LED signal and a voice warning \"Please be careful, carbon monoxide leak!\" or \"Please be careful, gas leak!\".\u003cbr\/\u003e\u003cbr\/\u003eSimultaneously with this warning message, the detector display shows the current measured value.\u003cbr\/\u003e\u003cbr\/\u003eThis combined detector of CO, flammable and explosive gases protects you and your family from two dangerous threats at the same time.\u003cbr\/\u003e\u003cbr\/\u003eThe device is powered by a 230V \/ AC network with a backup NiMH 9V battery in case of power failure in the electrical network (battery is not included in the package).\u003cbr\/\u003e\u003cbr\/\u003eTest function\u003cbr\/\u003eThe device is equipped with a test function, which is used to artificially simulate the presence of CO or gas and allows verification of the operability of the internal circuits through an automatic efficiency monitoring system.\u003cbr\/\u003e\u003cbr\/\u003eLCD display\u003cbr\/\u003eIt shows not only the current values ??of CO and flammable gas, but also other additional information such as the capacity of the backup battery via a bar graph, network connection, etc. The backlit LCD display allows recognition and comparison of low and high values ??of potential danger.\u003cbr\/\u003e\u003cbr\/\u003eVoice warning function\u003cbr\/\u003eThe acoustic signal of the alarm siren is accompanied by a human voice (in the Czech language) informing about the detected danger \"Please be careful, carbon monoxide leak!\" or \"Please be careful, gas leak!\".\u003cbr\/\u003e\u003cbr\/\u003eWhere to install the detector\u003cbr\/\u003eWe install combined detectors of carbon monoxide, flammable and explosive gases in rooms with the potential occurrence of CO or gas leakage (bathrooms, gas boiler rooms, kitchens, rooms with wavki, karma, direct heaters, heaters, etc.).\u003cbr\/\u003e\u003cbr\/\u003eThe basic criterion for the correct placement of the detector is gas identification, i.e. whether we will detect light gas (rises up to the ceiling) or heavy gas (falls to the floor).\u003cbr\/\u003e\u003cbr\/\u003eWe will choose the installation location according to this criterion. We always install the gas detector on the wall, depending on the type of gas detected, either under the ceiling (approx. 15-30 cm) or above the floor (approx. 15-30 cm), at a distance of at least 1.2 m from the fuel-burning device to minimize false alarms, which they can occur during a short gas leak, for example when lighting a gas boiler or stove and at a distance of approx. 60 cm from the corners, i.e. the place where two walls meet.\u003cbr\/\u003e\u003cbr\/\u003eProperties of gases and their weight relative to air\u003cbr\/\u003ePropane Butane (LPG): Heavier than air, sinks to the floor.\u003cbr\/\u003eCarbon monoxide (CO), natural gas (LNG, CNG): Lighter than air, rises up to the ceiling.\u003cbr\/\u003ePetroleum: Heavier than air, sinks to the floor.\u003cbr\/\u003eEthylene: Lighter than air, rises up to the ceiling.\u003cbr\/\u003e\u003cbr\/\u003eWhat is carbon monoxide?\u003cbr\/\u003eCarbon monoxide is a colorless, tasteless and odorless gas that is produced when fossil fuels such as coal, oil, natural gas, LPG, coal and wood are burned improperly. It can also be produced by poorly maintained or malfunctioning fuel-burning domestic heating appliances such as: boilers, gas appliances, cookers, grills, clogged chimneys, ventilation systems or damaged flue pipes.\u003cbr\/\u003e\u003cbr\/\u003eCommon symptoms of CO poisoning include headaches, nausea, fatigue or muscle pain - but these can easily be confused with a diagnosis of the flu.\u003cbr\/\u003e\u003cbr\/\u003eWhat is natural gas?\u003cbr\/\u003eNatural gas is piped into your home. Unless you live in the country, you probably use natural gas. It is the predominant energy for heating homes. Natural gas is a fossil fuel containing almost exclusively methane. Methane is much lighter than air and rises upwards when it escapes.\u003cbr\/\u003e\u003cbr\/\u003eIf you are a natural gas user, we recommend installing this detection device about 30 cm from the ceiling to ensure that a gas leak is detected as quickly as possible.\u003cbr\/\u003e\u003cbr\/\u003eWhat is propane?\u003cbr\/\u003ePropane is most often delivered to the home in liquid form and is stored near the house in propane tanks. Propane is used in homes in rural areas where natural gas is not installed. As propane is the most commonly used LPG (liquefied petroleum gas), pan and LPG are often used interchangeably. Unlike natural gas, propane is much heavier than air and stays low to the ground. We therefore recommend installing this detection device low to the floor to ensure the fastest possible detection of a gas leak.\u003cbr\/\u003e\u003cbr\/\u003eIt is therefore important to protect your family and home with carbon monoxide and flammable gas detectors.\u003cbr\/\u003e\u003cbr\/\u003eDevice benefits\u003cbr\/\u003eA unique combination of two devices for the detection of carbon monoxide and flammable gases\u003cbr\/\u003eVoice warning - informs about detected danger in a human voice\u003cbr\/\u003eAdvanced catalytic combustion and electrochemical sensor technology in one device\u003cbr\/\u003eDisplay of the current CO and gas concentration on the LCD display\u003cbr\/\u003ePowered by AC 90V-240V mains\u003cbr\/\u003eBackup power supply with 9V NiMH rechargeable batteries in case of power failure\u003cbr\/\u003eIntelligent detection control using a microprocessor\u003cbr\/\u003eInformation and warning LED indication\u003cbr\/\u003eTest function, verifying the proper functioning of the device\u003cbr\/\u003eSelf-monitoring detection system with automatic signaling of sensor failure\u003cbr\/\u003eBacklit LCD display for displaying measured values\u003cbr\/\u003eLoud alarm signaling alarm 85dB\u003cbr\/\u003eInstallation on the wall\u003cbr\/\u003eLow battery and sensor failure signaling\u003cbr\/\u003eLow operating costs, small dimensions and weight\u003cbr\/\u003eSimple assembly and handling\u003cbr\/\u003eModern and elegant design\u003cbr\/\u003e\u003cbr\/\u003eThis combined detector of carbon monoxide and flammable gases has a certificate confirming compliance with the requirements of the Czech technical standard ČSN-EN 50291-1:2010, Electrical devices for the detection of carbon monoxide in residential buildings and ČSN-EN 50194-1:2009, Electrical devices for the detection of flammable gases in residential buildings. Compliance with the standard was confirmed by the independent research laboratory TCT (Testing Certification Technology).\u003cbr\/\u003e\u003cbr\/\u003eTechnical parameters:\u003cbr\/\u003e\u003cbr\/\u003eCarbon monoxide (CO): Electrochemical CO sensor\u003cbr\/\u003eSensor sensitivity: Depending on ambient conditions (temperature, humidity) and sensor condition\u003cbr\/\u003edisplayed values ??may differ. The tolerances of the displayed values ??are as follows:\u003cbr\/\u003eAmbient: 27 °C +\/- 12 °C (80 °F +\/- 10 °F), atmospheric pressure +\/- 10%, 40% +\/- 3% relative humidity\u003cbr\/\u003eAlarm: 50ppm (60 - 90 minutes)\u003cbr\/\u003eFlammable gases: Catalytic combustion sensor\u003cbr\/\u003eSensor sensitivity: 2500ppm+\/ - 1500PPM (0.25% - 2% DMV\/LEL)\u003cbr\/\u003eAlarm: ? 2500ppm (0.25% DMV\/LEL)\u003cbr\/\u003eReaction time: Max. 20 s\u003cbr\/\u003eMains power supply: AC 230 V \/ 50-60 Hz\u003cbr\/\u003eInitialization time: 180 s\u003cbr\/\u003eBackup power: NiMH battery 9V (optional - battery not included)\u003cbr\/\u003eOperating time on backup battery: 2 h operating mode \/ 30 min alarm\u003cbr\/\u003eSignaling\u003cbr\/\u003eSound signaling: 85 dB \/ 0.3 m\u003cbr\/\u003eExceeding the permissible concentration: 85 dB acoustic alarm accompanied by a voice warning \"Please be careful, carbon monoxide leak!\" or \"Please be careful, gas leak!\" and a visual indication of the red LED indicator, information on the display about the detected concentration.\u003cbr\/\u003eLED signaling indication:\u003cbr\/\u003eAC power supply: the green LED indicator lights continuously\u003cbr\/\u003eAlarm: rapid flashing of the red LED\u003cbr\/\u003eMalfunction: the yellow LED indicator lights up permanently\u003cbr\/\u003eMounting method: On the wall (screws are included in the package)\u003cbr\/\u003eProtection: IP30\u003cbr\/\u003eWorking temperature: 0 °C to +50 °C\u003cbr\/\u003eWorking relative humidity: 10%-95%.\u003cbr\/\u003eStorage temperature: -10 °C to 50 °C\u003cbr\/\u003eDimensions: 112 x 73 x 42 mm\u003cbr\/\u003eLength of power cable: approx. 1.35 m\u003cbr\/\u003eApproval: EN 50194-1:2009 \/ EN50291-1:2010\u003cbr\/\u003eMarks: CE","brand":"SAFE","offers":[{"title":"Default Title","offer_id":52553391178066,"sku":"08831359","price":1399.0,"currency_code":"CZK","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0954\/9624\/1490\/files\/08831359.png?v=1776146106","url":"https:\/\/tipa-production.myshopify.com\/en\/products\/detektor-plynu-safe-808com-oxid-uhelnaty","provider":"TIPA","version":"1.0","type":"link"}