Thermal insulation foam PENOSIL 111 EasySpray cream 700ml

PENOSIL EasySpray Foam 111 is a one-component spray gun foam.

It is used to seal and insulate hard-to-reach places and surfaces where the use of traditional insulation materials is difficult.
It is characterized by a very low diisocyanate content and fast and convenient application.
The special spray nozzle is compatible with most foam guns.
Very low diisocyanate content (<0.1%).
Excellent air tightness and thermal and sound insulation properties.
Increased resistance to UV radiation.
Fast and easy application.
Excellent adhesion to most building materials.
Good ability to compensate for movements.
Any thickness of the insulation layer.
Nozzle compatible with most foam guns.

COLOR
Cream.

APPLICATION
Sealing and insulation of hard-to-reach places and uneven and rounded surfaces where it is difficult to use traditional insulation materials.
Thermal and acoustic insulation of lintels, doors, ceilings, pipes, attics, balconies, garages, cellars, containers, vehicles, tanks and other building elements exposed to thermal bridges.
Insulation of hard-to-reach surfaces and repair of existing insulation layer.
Reduction of thermal bridges.
Prevention of condensation on cold surfaces.
Adheres to: wood, concrete, bricks, stone, walls, plaster, plasterboard, metals, PVC and polystyrene.

APPLICATION PROCEDURE
Surfaces must be clean and free of dust, loose particles and oil stains.
For faster curing and better quality of the joint, moisten dry surfaces with water.
Attach the spray nozzle to the end of the foam gun.
Shake the can thoroughly at least 20 times.
Hold the can vertically with the valve upwards and screw it onto the gun.
Keep the can upside down during application.
The foam output can be adjusted using the gun trigger and the adjusting screw.
Turn the spray nozzle as required.
Apply the foam from a distance of approximately 40 cm.
The maximum thickness of one layer is 2 cm.
Wait at least 60 minutes before applying the next layer.
The number of layers is not limited.
When applying layers, each subsequent layer should be slightly moistened with water.
Excess hardened foam can be removed mechanically, e.g. with a knife.

LIMITATIONS
Does not adhere to polyethylene (PE), PTFE (Teflon®) or silicone.
Do not use at temperatures below +10 °C.
The hardened foam is less sensitive to UV radiation than other PU foams, but it is still recommended to protect it with a suitable protective material.
Do not cover the foam until it has completely hardened.
Nozzle compatible with most foam guns - it is recommended to check compatibility before choosing a gun.

SURFACE PREPARATION
Air temperature during use: +10°C to +30°C.
Adjacent surfaces should be protected with paper, protective foil or other suitable material.
Due to the variety of building materials, a preliminary compatibility test is recommended.
When applying at low temperatures, the foam should be warmed to room temperature (approximately +20°C).

CLEANING
To remove fresh foam, use PENOSIL 929 foam cleaner.

PENOSIL 995 foam remover softens hardened foam and makes it easier to remove.

STORAGE
The guaranteed shelf life is 12 months from the date of production, provided that it is stored in its original, unopened packaging in a cool, dry place at a temperature between +5°C and +30°C. Do not expose to temperatures above +50°C, do not store near heat sources or in direct sunlight. Store and transport in an upright position.

SAFETY REQUIREMENTS
Pressurized container. Use only in well-ventilated areas. Do not smoke during application! Wear personal protective equipment if necessary. Keep out of reach of children. For more detailed safety information, see the label and the Safety Data Sheet (SDS).